Your new That’s My Seat custom recliner just arrived! Follow these simple steps for quick assembly:
Recliner Assembly

Step 1
Begin by opening the box. Peel the tape from the top of the box. DO NOT use any sharp objects, this could damage your chair!
Remove all packaging materials and place the recliner back in the seat of the recliner.
Remove the white packing material from the mechanism.



Step 2
Grab each side of the back about halfway up holding the back flap with your thumbs.



Step 3
Align the clips on each side in the back with the back post of the mechanism.



Step 4
Firmly push down on the back until the back clips snap in place.



Step 5
Attach the snaps on each end of the unit and then fold the bottom part of the back flap under the base securing it with the Velcro.



Step 1
Begin by opening the box. Peel the tape from the top of the box. DO NOT use any sharp objects, this could damage your chair!
Remove all packaging materials and place the recliner back in the seat of the recliner.
Remove the white packing material from the mechanism.



Step 2
Grab each side of the back about halfway up holding the back flap with your thumbs.



Step 3
Align the clips on each side in the back with the back post of the mechanism.



Step 4
Firmly push down on the back until the back clips snap in place.



Step 5
Attach the snaps on each end of the unit and then fold the bottom part of the back flap under the base securing it with the Velcro.


Step 6
Connect the two ends of the transformer, being sure to secure them together with the attached clip. Connect the female end to the motor, also clip in place.